Chapter 4
Advanced Configuration
14
10/100 16-Port VPN Router
Each of the servers on the DMZ will need a unique, public
Internet IP address. The ISP you use to connect your
network to the Internet should be able to provide these
addresses, as well as information on setting up public
Internet servers. If you plan to use the DMZ setting, contact
your ISP for the static IP information.
The DMZ Setting table displays the DMZ port name in
the Interface column and its IP address in the IP Address
column. Click
Edit
in the Config. column to change the
DMZ settings of the DMZ port.
Edit DMZ Connection
After you clicked Edit, configure the DMZ settings.
Interface
The DMZ port will be displayed.
Static IP is automatically selected.
DMZ
Specify DMZ IP Address
Enter the IP address of the
computer connected to the DMZ port.
Subnet Mask
Enter the subnet mask of the computer
connected to the DMZ port.
Click
Save Settings
to save your changes, or click
Cancel
Changes
to undo them. Click
Back
to return to the
Network
screen without saving any changes.
Setup > Password
The Router’s default User Name and Password is
admin
,
and Linksys strongly recommends that you change the
Router’s password from the default to a unique password.
NOTE:
The password cannot be recovered if
it is lost or forgotten. If the password is lost or
forgotten, you have to reset the Router to its
factory default settings; this will remove all of
your configuration changes.
Setup > Password
Password
The User Name is
admin
; it cannot be changed.
Old Password
Enter the old password. The default is
admin
when you first power up the Router.
New Password
Enter a new password for the Router. Your
password must have 20 or fewer characters and cannot
contain any spaces.
Confirm New Password
Re-enter the new password to
confirm it.
Click
Save Settings
to save your change, or click
Cancel
Changes
to undo it.
Setup > Time
The Router uses the time settings to time stamp log events,
automatically apply the Access Rules and Content Filter,
and perform other activities for other internal purposes.
Time
To set the local time, select
Set the local time using the
Network Time Protocol (NTP) automatically
or
Set the
local time Manually
.
Automatic
Setup > Time > Automatic
Time Zone
Select your time zone. The default is
(GMT-
08:00) Pacific Time (US & Canada); Tijuana
.
