Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device, Configuration Manual

Page: 80 / 432

Chapter 4 Using the Configuration Manager
Configuring the Device
4-14
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-05
Wildcards should be used with care to avoid any unwanted rewriting of
references.
6.
To see the results of these URL rewrite rules in the server configuration, enter
the following command. The results are presented below it.
(config-ssl-server[myServer])# show ssl server myServer
...
URL Rewrite:
Name Clear Port SSL Port Redirect Only
__________________________________________________________________
www.mybusiness1.com 443 81 No
www.mybusiness2.com 443 81 Yes
*.mybusiness3.com 443 81 No
For more information about URL rewriting, contact your Cisco representative for
a copy of the white paper SSL Offloaders and Contextual Consistency.
Example: Configuring SNTP Servers
Up to four SNTP servers can be configured on the Secure Content Accelerator.
Note To provide increased security, we recommend using an SNTP server
on the internal network. Using an external SNTP server might
compromise network security.
1.
Open a management session with the device.
2.
Enter Privileged and Configuration modes:
SCA> enable
SCA# configure
(config[SCA])#
3. Enter the IP addresses or host names of up to four SNTP servers. (Host names
are resolved to IP addresses in the device configuration.)
(config[SCA])# sntp server 10.1.24.2
(config[SCA])# sntp server 10.1.24.4
(config[SCA])# sntp server 10.2.22.2
(config[SCA])# sntp server 10.2.22.6
(config[SCA])#