Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device, Configuration Manual

Page: 68 / 432

Chapter 4 Using the Configuration Manager
Overview
4-2
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-05
Overview
Whether used via serial or telnet connection, the command line interface
configuration manager provides greater control over the SSL appliance than the
QuickStart or Secure Server wizard alone.
The configuration manager allows you to control hardware and SSL portions of
the appliance through a discreet mode and submode system as shown in the
hierarchy diagram in Figure 4-1.
Figure 4-1 Configuration Manager Hierarchy
To configure items in a submode, activate the submode by entering a command in
the mode above it. For example, to set the network interface speed or duplex you
must first enter enable, configure, then interface network. To return to the
higher Configuration mode, simply enter end or exit or press CTRL+D. The
finished command returns to the Top Level from any mode. Appendix C lists all
commands for SSL devices.
Note
Refer to Chapter 6 for FIPS Mode instructions.
SSL INTERFACE
KEY SECURITY
POLICY
CERTIFICATE
CERTIFICATE
GROUP
PRIVILEGED
NON-PRIVILEGED
TOP LEVEL
COMMANDS
CONFIGURATION
TCP-TUNING SERVER
TCP-TUNING
BACKEND
SERVER
TCP-TUNING
REVERSE-PROXY
SERVER
TCP-TUNING