Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device, Configuration Manual

Page: 372 / 432

Appendix C Command Summary
Configuration Command Set
C-180
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-05
slow-start
Controls use of an algorithm determining the rate at which packets should be
injected onto the network based upon the rate at which acknowledgements are
received.
slow-start <0|1|on|off|default>
no slow-start
Syntax Description
Usage Guidelines
Availability: Serial, Telnet; FIPS Mode (serial only)
This is designed to deal with unknown variables, such as link speed and latency,
and intermediate router loads on the network traversal path. The slow-start
algorithm uses a variable congestion window setting that increments and
decrements as segments are successfully or unsuccessfully acknowledged. Any
time the quality, latency, or speed of any portion of the network is unknown (e.g.,
the Internet) it is a safe idea to leave slow-start enabled. Use the no form of the
command to return the slow-start to the global value. If no global settings exist
for a parameter, the factory default parameter is used instead. See RFC 2001 and
RFC 2581.
stdurg
Controls the octet pointed to by the urgent pointer.
stdurg <0|1|on|off|default>
no stdurg
0 slow-start is disabled.
1 slow-start is enabled.
on slow-start is enabled.
off slow-start is disabled.
default 1 (on); slow-start is enabled