Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device, Configuration Manual

Page: 380 / 432

Appendix D MiniMax Command Summary
Examples
D-6
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-05
9. On the SSL device’s console, you should see a display similar to the
following:
>>accepted netboot connection from 10.1.6.145:2056
transfer completed 1951970 bytes received
Image address: 0x3a56350
Image length: 951826
Signed: yes
Image type: PHR/PHX file
csid: 0x460313d8
version: 0x00004000
system: 0x00000001
product: 0x00000005
arch: 0x00000007
type: 0x00000006
use zap to save to flash
10. Enter the following commands to save the image and restart the device.
>>zap
>>boot
11.
Messages are written to the console, indicating necessary files are written.
The device will reboot into the serial console configuration manager.
Installing a MaxOS Image (Xmodem)
This example uses the Xmodem to download the image to MiniMax over the
console serial line. The MaxOS image can be found on the distribution CD
accompanying the device.
1.
Launch any terminal emulation application that communicates with the serial
port connected to the SSL device and supports the Xmodem protocol. Use
these settings: 9600 baud, 8 data bits, no parity, 1 stop bit, no flow control.
2. 3. Enter the do command at the MiniMax prompt. The following is displayed.
>>do
>>
Downloading
SSSS
Note
The "S" is actually a non-ASCII character sent to the screen
while MiniMax is waiting for the file to be sent.