Cisco Catalyst 3650 Series, Command Reference Manual

Page: 871 / 1108

vlan filter
To apply a VLAN map to one or more VLANs, use the vlan filter command in global configuration mode
on the switch stack or on a standalone switch. To remove the map, use the no form of this command.
vlan filter mapname vlan-list { list| all }
no vlan filter mapname vlan-list { list| all }
This command is not supported on switches running the LAN Base feature set.
Note
Syntax Description
Name of the VLAN map entry. mapname
Specifies which VLANs to apply the map to. vlan-list
The list of one or more VLANs in the form tt, uu-vv, xx, yy-zz, where spaces
around commas and dashes are optional. The range is 1 to 4094. list
Adds the map to all VLANs. all
Command Default
There are no VLAN filters.
Command Modes
Global configuration
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
To avoid accidentally dropping too many packets and disabling connectivity in the middle of the configuration
process, we recommend that you completely define the VLAN access map before applying it to a VLAN.
For more information about VLAN map entries, see the software configuration guide for this release.
Examples
This example applies VLAN map entry map1 to VLANs 20 and 30:
Device(config)#
vlan filter map1 vlan-list 20, 30
This example shows how to delete VLAN map entry mac1 from VLAN 20:
Device(config)# no vlan filter map1 vlan-list 20
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
845
vlan filter