Cisco Catalyst 3650 Series, Command Reference Manual

Page: 311 / 1108

channel-group
To assign an Ethernet port to an EtherChannel group, or to enable an EtherChannel mode, or both, use the
channel-group command in interface configuration mode. To remove an Ethernet port from an EtherChannel
group, use the no form of this command.
channel-group { auto | channel-group-number mode { active | auto [ non-silent ]| desirable [ non-silent ] | on|
passive }}
no channel-group
Syntax Description
Enables auto-LAG feature on
individual port interface.
By default, the auto-LAG feature
is enabled on the port.
auto
Channel group number. The range
is 1 to 128. channel-group-number
Specifies the EtherChannel mode. mode
Unconditionally enables Link
Aggregation Control Protocol
(LACP). active
Enables the Port Aggregation
Protocol (PAgP) only if a PAgP
device is detected. auto
(Optional) Configures the interface
for nonsilent operation when
connected to a partner that is
PAgP-capable. Use in PAgP mode
with the
auto
or
desirable
keyword
when traffic is expected from the
other device.
non-silent
Unconditionally enables PAgP.
desirable
Enables the on mode.
on
Enables LACP only if a LACP
device is detected.
passive
Command Default
No channel groups are assigned.
No mode is configured.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
285
channel-group