Cisco Catalyst 3650 Series, Command Reference Manual

Page: 663 / 1108

debug auto qos
To enable debugging of the automatic quality of service (auto-QoS) feature, use the debug auto qos command
in privileged EXEC mode. Use the no form of this command to disable debugging.
debug auto qos
no debug auto qos
Syntax Description
This command has no arguments or keywords.
Command Default
Auto-QoS debugging is disabled.
Command Modes
Privileged EXEC
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SE
Usage Guidelines
To display the QoS configuration that is automatically generated when auto-QoS is enabled, enable debugging
before you enable auto-QoS. You enable debugging by entering the
debug auto qos
privileged EXEC
command.
The undebug auto qos command is the same as the no debug auto qos command.
When you enable debugging on a device stack, it is enabled only on the active device. To enable debugging
on a stack member, you can start a session from the active device by using the
session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the active
device to enable debugging on a member device without first starting a session.
Examples
This example shows how to display the QoS configuration that is automatically generated when auto-QoS is
enabled:
Device# debug auto qos
AutoQoS debugging is on
Device#
configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Device(config)# interface gigabitethernet2/0/1
Device(config-if)# auto qos voip cisco-phone
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
637
debug auto qos