3-23
Cisco 6260 Hardware Installation Guide
OL-2365-02
Chapter 3 Installing a Cisco 6260 with a POTS Splitter Configuration
Installation Procedures
•
Interfaces whose names begin with “ATM1” through “ATM32” are line card interfaces. (NI-2 slots,
ATM10 and ATM11, are omitted.)
For line card interfaces, the number before the slash indicates the slot number. The number after the
slash indicates the interface or port number. For example, ATM6/4 is slot 6, port 4.
•
Ethernet0/0 is the interface for the LAN that connects the Cisco 6260 to its management system.
3.2.19.2.2 Basic Management Setup Example
This is the basic management setup example:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]:
y
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]:
y
Configuring global parameters:
Enter host name [DSLAM]:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret:
beansoup