－
129
－
(3) When changing the setting from this recorder for appropriate CH of low order instrument, perform
following procedure. (The instrument which is not change the setting is not displayed transfer all
points transfer button.)
When change the setting only displayed CH, tap transmitting button. In case of changing and setting
of all needed CH, tap all points button after finishing the change of all setting. Following message is
shown when input of setting contents is done normally. After sending contents of setting is complete,
the following message is displayed.
Tap OK button for returning.
If the input is incorrect, the following message is displayed.
Tap OK button for returning, and tap INPUT button again. When message of “INPUT Complete” is
not shown, communication is not normal. Check the setting and connection of this instrument and
low order instruments again.
(4) After finish the setting of CH, tap the ESC key and save the setting.
(5) After setting of the above procedure, start data acquisition. When register the CH which is allotted to
low order instrument at [display setting] – [group parameter], data of low order instrument can be
displayed and recorded (refer to 13.3.2).
