Case CX130C, Operator'S Manual

Page: 128 / 282

4 - OPERATING INSTRUCTIONS
Moving the unit
Machine travel
WARNING
Controls can be reversed!
In the normal travel position, the operator's compartment is above the idler wheels and the travel
reduction gears are to the rear of the upper structure. If the upper structure is turned 180 degrees in
relation to the undercarriage, the controls are reversed.
Failure to comply could result in death or serious injury.
W0289A
WARNING
Hazard to bystanders!
Always sound the horn before starting the machine. Make sure the work area is clear of other persons,
domestic animals, tools, etc. before you operate the machine. Never allow anyone in the work area
during machine operation.
Failure to comply could result in death or serious injury.
W0304A
NOTE: increase the engine speed before start traveling.
Fold the attachment to raise it to 40 – 50 cm ( 15.7 –
19.7 in ) above ground.
NOTICE: Before start traveling with CX130C with blade,
make sure to fully raise the blade in order not to stick on
the ground while traveling. Make sure to avoid interfer-
ence between the blade and the bucket when the front
equipment is set in position for traveling or transport.
Selection of travel speed
WARNING
Loss of control hazard!
Avoid pressing the travel speed button while
traveling. Avoid shifting to FAST speed when
traveling downhill or when loading/unloading
from a trailer.
Failure to comply could result in death or se-
rious injury.
W0390A
Before start traveling, make sure to select the proper
travel mode between "Turtle" and "Rabbit".
As the travel mode is selected, the travel speed varies
with the tilting angle of the travel control levers and pedals.
Refer to Chapter 8 for speed ranges.
SMIL17CEX0152AA
1
Travel alarm
The travel alarm sounds depending on the position of the
switch located on the right hand console:
AUTO OFF position: the alarm sounds for only 10 s
each time the travel controls are activated.
CONT position: the alarm sounds continuously each
time the travel controls are activated.
4-16