6 - MAINTENANCE
Pilot line filter
WARNING
Burn hazard!
Before performing any service on the hydraulic system, you must allow it to cool. Hydraulic fluid
temperature should not exceed 40 °C (104 °F).
Failure to comply could result in death or serious injury.
W0241A
WARNING
Pressurized system!
Never attempt to drain fluids or remove filters when the engine is running. Turn off the engine and
relieve all pressure from pressurized systems before servicing the machine.
Failure to comply could result in death or serious injury.
W0905A
Replace the pilot line filter every
1000 h
(After
250 h
of operation in run-in period).
NOTICE:
when the machine is a new vehicle, or when the main components of the hydraulic system are already
overhauled or replaced, replace the oil return filter after
250 h
of operation. After that, replace the filter at specified
intervals.
1. Release all the pressure in the hydraulic tank. Refer to
page
6-11
.
2. Open the side hood and locate the pilot line filter.
3. Loosen the nut positioned on the filter body.
4. Pull out the pilot line filter element and clean the filter
housing.
5. Install the new filter and tighten.
SMIL16MEX0441AA
1
6-46
Summary of Contents for CX37C
