4 - OPERATING INSTRUCTIONS
Bucket replacement
WARNING
Flying object!
Always wear eye or full face protection when
performing this procedure.
Failure to comply could result in death or se-
rious injury.
W0313A
1. Lower the bucket to the ground.
NOTE:
place the bucket in light contact with the
ground. If the bucket is lowered strongly to the ground,
the resistance will be increased and it will be difficult
to remove the pins
2. Put the safety lever in LOCK position (safety lever in
rearward position), and stop the engine.
SMIL16MEX0040AA
1
3. Remove the stopper bolts
(1)
and the nuts
(2)
, then
remove the pins
(3)
from the arm
(B)
and the pin
(4)
from the link
(C)
.
4. Remove the bucket
(A)
.
NOTE:
after the removal of the pins, make sure that
they are not contaminated with sand or mud and that
the seals of the bushing on both sides are not dam-
aged.
SMIL16MEX0041AB
2
5. Align the arm
(B)
with the holes
(D)
and the link
(C)
with the holes
(E)
, then coat with grease and install
the pins
(3)
and
(4)
.
6. When installing the bucket, the O-rings
(5)
are eas-
ily damaged, so fit the O-rings
(5)
on the boss of the
bucket.
7. After knocking the pins, move the O-ring down to the
regular groove. Install the stopper bolts
(1)
and the
nuts
(2)
for each pin, then grease the pin.
SMIL16MEX0042AB
3
SMIL16MEX0043AB
4
4-12
Summary of Contents for CX37C
