5 - TRANSPORT OPERATIONS
Unloading the machine from a transport trailer
Rear loading type transport trailer
1. Position the trailer on firm and level ground. Put blocks
at the tires of trailer to prevent trailer from moving.
2. Remove wire ropes, chocks, blocks and other devices
used to secure the machine during road transport.
3. Prepare the loading ramps. If the ramps are included
in the trailer frame, lower them to the ground. If the
ramps are external to the trailer, match them to the
rear edge of the trailer avoiding any bump between
trailer bed and external ramps.
NOTICE:
the ramp slope should be
15°
or less.
4. Get on the machine and start the engine.
5. Select the low travel mode.
6. Raise the dozer blade and operate the arm and bucket
controls so the bottom of the bucket is about
20 cm
(
7.9 in
) above the trailer bed.
NOTICE:
in this position, traveling and steering control
become opposite to each other.
7. Travel slowly towards the back of the trailer and stop
as you reach the ramps. Operate the boom and the
arm softly in order to get the bucket close to the ground
ahead of the ramps.
NOTICE:
avoid fully extending the bucket cylinder to
prevent damaging it due to accidental impacts with the
ground.
8. Move down on ramps with extreme care while operat-
ing the boom and the arm softly in order to keep the
bucket close to the ground and so to grant machine
stability.
9. Pass through the ramps completely and stop the ma-
chine once it gets on the ground.
SMIL16MEX0405AA
1
5-4
Summary of Contents for CX37C
