85
TRIMMING REFRIGERANT CHARGE — The 19XR
chiller is shipped with the correct charge for the design duty of
the chiller. Trimming the charge can best be accomplished
when the design load is available. To trim the charge, check the
temperature difference between the leaving chilled water tem-
perature and cooler refrigerant temperature at full load design
conditions. If necessary, add or remove refrigerant to bring the
6
10
7
1a
11
8
1b
5
3
4
2
PUMPOUT
COMPRESSOR
RELIEF
VALVE
PUMPOUT
CONDENSER
CHECK
VALVE
CONDENSER
COOLER
STORAGE VESSEL
OIL
SEPARATOR
Fig. 43 — Typical Optional Pumpout System Piping Schematic with Storage Tank
a19-2434
NOTE: Maintain at least 2 ft (610 mm) clearance around storage tank for service and operation work.
7
1a
11
8
1b
5
3
4
2
PUMPOUT
COMPRESSOR
OIL
SEPARATOR
RELIEF
VALVE
PUMPOUT
CONDENSER
CHECK
VALVE
CONDENSER
COOLER
Fig. 44 — Typical Optional Pumpout System Piping Schematic without Storage Tank
a19-2435
Summary of Contents for AquaEdge 19XR series
