Canon VB-C300, Administrator'S Manual

Page: 224 / 302

Operation Guideline for Recording and Viewing
224
Recording Frame Rate Adjustment
●
Reduce recording frame rate when disk is under high load in the
Storage Server Configuration dialog (
➝
P. 57)
* This option is enabled by default (recommended).
When the network recording software writes images received from cameras into the hard
disk, if the load (mainly the load of writing into the hard disk) of the PC on which the
Storage Server is running is too high, the software cannot write the images immediately.
If the amount of the image that is waiting to be written increases for a certain period of
time, the Storage Server considers the PC to be highly loaded. When this happens, the
Storage Server stores images at intervals rather than storing all of the images the Storage
Server received, in order to reduce the PC load.
If you use this function, you can avoid recording failure as much as possible even if your
PC temporarily becomes highly loaded for some reasons. When using this setting, adjust
the video recording frame rate so that it does not drop below 0.5 fps.
Note that events are generated when the network recording software starts and ends the
operation of the function (
➝
P. 288, “Changing the Recording Frame Rate”). You can
check the operating status of the function via the Event Search dialog (
➝
P. 214).
If you do not use this function, recording may be interrupted when the load on your PC is
high. This software cannot detect the recording interruption.
This function is disabled when the Resolution is set to MPEG-4.
COP
Y