5
5
5-9
5-9
Adjustment > Action on parts replacement > Checking the position attached the Swing Guide Unit
Adjustment > Action on parts replacement > Checking the position attached the Swing Guide Unit
Action on parts replacement
Checking the position attached the Swing Guide Unit
CAUTION:
When attaching the swing guide unit, swing guide upper cover and swing guide open
solenoid (SL101), check the gap between the swing guide upper cover and the arm
of the staple safety switch.
1) Raise the swing guide unit while pushing the plunger of the swing guide solenoid, and
then check that the gap between the swing guide upper cover and the arm of the staple
safety switch is within 1.5±0.5mm.
If the gap is outside the standard, adjust according to the following steps 2) to 3).
1.5±0.5mm
F-5-16
F-5-16
2) Loosen two screws and shift the position of the swing guide open solenoid to adjust the
position of the staple safety switch's arm. Then, tighten two screws.
3) Check whether the gap between the swing guide upper cover and the arm of the staple
safety switch is within 1.5±0.5mm. If the gap is outside the standard, adjust again.
CAUTION:
If the gap between the swing guide upper cover and the arm of the staple
safety switch is outside the standard, it might defective movement.
F-5-17
F-5-17
Summary of Contents for Staple Finisher-D1
