COPYRIGHT© 2001 CANON INC.
2000 2000 2000 2000
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
5-20
CHAPTER 5 TROUBLESHOOTING
•
The saddle sticker assembly will stitch
the sheets, folds them, and delivers
them automatically.
10) Measure the distance (L) between the
stitching position and the folding posi-
tion. Use either 'positive adjustment
width' or 'negative adjustment width' to
suit the relationship between the posi-
tions.
•
If the stitching position is below the
folding position, use 'positive adjust-
ment width'.
•
If the stitching position is above the
folding position, use 'negative adjust-
ment width'.
F05-101-38
L
L
Unit: mm
EX: If L is 2 mm, '2 mm'.
Unit: mm
EX: if L is 1.5 mm, 1.5 mm.
Positive adjustment
width
Negative adjustment
width
Marking
Marking
Folding position
Stitching position
Stitching position
Folding position
11) By referring to the table that follows,
change the setting of bits 6 through 8 of
SW1.
•
If the adjustment width is 0,
The stitching position and the folding
position are correctly matched. Do not
change the setting.
•
If for 'positive adjustment width',
Subtract the interval from the value in
T-$, and change the setting of SW1.
EX:If the current setting of SW1 is +2 and
the interval is +2 mm, set SW1 to -2.
•
If for 'negative adjustment',
Add the interval to the value in T-$, and
change the setting of SW1.
EX:If the current setting of SW1 is -1 and
the interval is -1.5 mm, set SW1 to +2.
bits of SW1
bit 6
OFF
OFF
OFF
OFF
ON
ON
ON
bit 7
ON
ON
OFF
OFF
OFF
ON
ON
bit 8
ON
OFF
ON
OFF
ON
OFF
ON
Setting
(in mm)
+3
+2
+1
0
-1
-2
-3
Do not change the following bits:
bit 6
ON
bit 7
OFF
bit 8
