COPYRIGHT© 2001 CANON INC.
2000 2000 2000 2000
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
3-9
CHAPTER 3 MECHANICAL SYSTEMS
1.1.4-4 Checking the Height
Connect the finisher to the copier, and
check the height. If the height is not as indi-
cated, make adjustments once again. If ap-
propriate, tighten all fixing nuts, and fit the
foot covers (front, rear).
F03-101-17a
1.1.5 Correcting the Slope
If the floor tilts the finisher, correct the
slope as follows; be sure to adjust the height
of the machine before starting the work:
1.1.5-1 Checking the Slope and Making
Preparations
1) Check to find out which way the ma-
chine tilts.
•
The gap between the finisher and the
copier is 5 ± 0.3 mm. If the gap is larger
than this, assume slope A and perform
step 5-2; if it is smaller, assume slope B
and perform step 5-3.
F03-101-17b
Memo
To adjust, turn the two casters
shown in F03-101-18.
F03-101-18
Gap at bottom: 5 0.3 mm
Gap at bottom: 5 0.3 mm