COPYRIGHT© 2001 CANON INC.
2000 2000 2000 2000
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
3-77
CHAPTER 3 MECHANICAL SYSTEMS
3.3.4 Adjusting the No. 1 Folding
Path Guide Plate
1) Remove the front cover and the rear
cover.
2) Remove the four screws, and detach the
belt cover (front, rear).
3) Remove the folder driver PCB.
4) Tighten the two screws each (front, rear;
[1]) temporarily.
F03-303-10
5) Turn the four adjusting screws indicated
in step 4) so that the gap between the
top edge of the lower left guide [2] and
the folding roller A [3] and the gap be-
tween the bottom edge of the lower left
guide and the left guide [4] (between rib
tops) is 1.6 ± 0.3 mm.
F03-303-11
3.3.5 Adjusting the Position of the
Left Guide Static Eliminator
1) Open the upper cover, and slide out the
folder unit.
2) Remove the right lower cover, and open
the left guide.
3) Loosen the two adjusting screws, and
adjust so that the protrusion of the static
eliminator 1 [1] from the guide face (not
the rib top) for the left guide is 1 ± 0.3
mm.
F03-303-12
[1]
[1]
1.6 0.3mm
[4]
[2]
[3]
1 0.3mm
[1]