Canon OMNERA 400T, Planning Manual

Page: 18 / 90

Environment Specifications
Planning Guide 0180-095-485 OMNERA™400T
Page 2-10
Wall Specifications
The walls are normally only used for mounting the cable outlets for the Ceiling suspended x-
ray support, the Wallstand and the System cabinet. Therefore, the only specification for the
walls, is that it must be possible to mount and secure the cable outlets. Screws, bolts or similar
for mounting the cable outlets, must be supplied (not included in shipment). The regulations
and specifications on page 2-1 must be followed.
The Installation cube shall be mounted to the wall. There are four wall fixation points, and each
fixation point must withstand a load of at least 0.5 kN. The wall attachment allows to place the
installation cube 0-1000 mm from the wall. If the distance to the wall is small, the attachment
must be shortened to a correct length. When the Installation cube is placed close to the wall,
make sure that a suitable placement of the cable outlet is possible.
Figure 2-7
750
750
750
750
Minimum distance, 0 mm
Maximum distance, 1000 mm
0.5kN
0.5kN
0.5kN
0.5kN
76
86
4
0
22
10.5 (2x)