Canon OMNERA 400T, Planning Manual

Page: 11 / 90

Environment Specifications
OMNERA™400T 0180-095-485 PlanningGuide
Page 2-3
Ceiling / Floor / Wall Specifications
The performance of the System is highly depending on the pre-installation work that has to be
done on the ceiling, floor and wall.
The Manufacturer does not take responsibility of the ceiling, floor or wall construction. The
Manufacturer recommends the ceiling, floor and wall to be leveled 1mm/m. Local regulations
and specifications must be observed.
The specifications specified in this section do not apply for risk regions for earthquakes. For
more information and specifications regarding risk assessments and calculations, please con-
tact the Manufacturer’s sales department.
Local regulations and specifications must also be observed. The forces listed in this document
are not always in correspondence to the local and/or national regulations.
Included in Shipment
•
Expansion bolts (standard type) for the Table and the Wallstand.
•
Expansion bolts (standard type) for the Installation cube (option).
•
A drilling template for the Table and a marking template for the Wallstand.
•
Spacers for the Table, Wallstand and Ceiling suspended x-ray tube support installa-
tion cube (option).
•
Insulation kits for all System components.
•
Mounting kit for the ceiling rail Y (Unistrut mounting brackets, etc.). See Figure 2-1 .
Figure 2-1
•
Mounting kit for the installation cube (wall mounting brackets, etc.) (option).
General Information Not Included in Shipment
•
Appropriate sub construction for the ceiling rail Y, e.g. Unistrut, must be provided (not
included in shipment).
•
Cable ducts or similar must be supplied (not included in shipment).
•
Screws, bolts, or similar for mounting the cable outlet for the Ceiling support must be
supplied (not included in shipment).
•
Alignment tools, such as rotating lasers or similar, must be supplied (not included in
shipment).