Canon CXDI-50C, Service Manual

Page: 76 / 195

2. Installation Manual
- 59 -
factors have been adjusted.
The specifications are as
follows although they cannot
be set at the present time:
14" x 14" : W=4444, H=4444
(for portraits)
11" x 14" : W=4444, H=3660
(for portraits)
Fuji CR-DPL/LPD/FM-
DPL + FN-PS551 -A 300 -T NO -M CUBIC -m
MEDIUM -S –P NORMAL –
B BLACK –k 2 –S ? (Site
Dependent)
(entered in param member)
14x17
3520 (entered in W member)
4280 (entered in H member)
14x14
3520 (entered in W member)
3490 (entered in H member)
11x14
2540 (entered in W member)
3600 (entered in H member)
•
Trimming OFF
•
Cubic spline interpolation
•
SHARP, MEDIUM or SMOOTH can be
selected from among the presettings as
the smoothing type. An AVR of 0.8 or
so is appropriate. The setting is
performed for each printer on-site.
•
-S should be adjusted at the user’s site.
•
LUT can be selected from among the
eight presettings 1 through 8 using
Config Info. The setting is performed
for each printer on-site.
•
With -k 2, the Window Center/Level for
DICOM TAG (0028,1050) and (0028,
1051) are also deleted.
•
Maximum density: 3.00
A density of 3.20 cannot be designated.
For this reason, a non-linear LUT is
required.
Konica Drypro 722 +
Printlink -A 320 -T NO -M CUBIC -m
2 -S “KC_LUT=1” –O
PORTRAIT –P NORMAL –B
BLACK
(entered in param member)
80 (entered in pixel pitch
member)
14x17
4424 (entered in W member)
5324 (entered in H member)
14x14
4424 (entered in W member)
4372 (entered in H member)
11x14
3436 (entered in W member)
4424 (entered in H member)
•
Trimming OFF
•
Cubic spline interpolation
•
Smoothing type
1: BILINEAR
2: Sharp by spline interpolation
3: Slightly weak by spline interpolation
4: Weaker by spline interpolation
•
Maximum density: 3.20
Maximum density 3.20 could not be
achieved before.
Konica Li-62P + Printlink -A 320 -T NO -M CUBIC -m
2 -S “KC_LUT=1” –O
PORTRAIT –P NORMAL –B
BLACK
80 (entered in pixel pitch
member)
14x17
4268 (entered in W member)
5108 (entered in H member)
14x14
4268 (entered in W member)
4104 (entered in H member)
11x14
3204 (entered in W member)
4268 (entered in H member)
•
Trimming OFF
•
Cubic spline interpolation
•
Smoothing type
1: BILINEAR
2: Sharp by spline interpolation
3: Slightly weak by spline interpolation
4: Weaker by spline interpolation
•
Maximum density: 3.20
Before, maximum density 3.20 could
not be achieved.