Canon CXDI-50C, Service Manual

Page: 70 / 195

2. Installation Manual
- 53 -
* The designation method
varies according to the
printer. For example, the
MLP190 uses -m
NORMAL.
* This parameter is used in the
DICOM Basic Film Box
(2010, 0150).
-S configuration
Adjustment information
(character string) * This parameter sets the
printer (image quality)
adjustment from the SCU
side.
* In the DICOM standards,
value to be transferred is not
predetermined.
* The designation method
varies according to the
printer.
* This parameter is used in the
DICOM Basic Film Box
(2010, 0040).
Æ If this parameter is not designated, it is
not transferred over DICOM. In this case,
the printer default values are used. When
this parameter is not transferred, problems
can occur since unsuitable default values
may be used.
* This parameter is determined by asking
the printer engineer or by viewing the
conformance statement.
-O Orientation
Film orientation
(PORTRAIT/LANDSCAP
E)
* In versions before 2.0,
printers must operate based
on this parameter.
* When using image cutout
from 17 x 17 inch size in the
CXDI, this parameter is set
and transferred
automatically.
* This parameter is used in the
DICOM Basic Film Box
(2010, 0130).
Æ If this parameter is not designated, it is
not transferred over DICOM. In this case,
the printer default values are used.
* Starting from version 2.0, the image can
be rotated from the CXDI side without
using this parameter.
-A max_density
Maximum density
(Dx100)
* This parameter designates
the density of the digital
value for 0 (4095 for reverse
display) of the CXDI
transfer data image pixels.
(In the CXDI, 0 indicates
black.)
* In the CXDI, this parameter
is used to adjust the density.
Therefore, be sure to always
check that it is operating.
Æ If this parameter is not designated, it is
not transferred over DICOM. In this case,
the printer default values are used. When
this parameter is not transferred, problems
can occur since unsuitable default values
may be used.
–a min_density
Minimum density (Dx100) * This parameter is used in the
DICOM Basic Film Box
(2010, 0120).
* This parameter designates
the density of the digital
value for 4095 (0 for reverse
display) of the CXDI
transfer data image pixels.
(In the CXDI, 4095
indicates white.)
* This parameter is not
transferred in many cases
since the minimum density
cannot be increased in most
printers.
Æ If this parameter is not designated, it is
not transferred over DICOM. In this case,
the printer default values are used. When
this parameter is not transferred, problems
can occur since unsuitable default values
may be used.