Caltest LXI 3120AFX, Manual

Page: 385 / 402

AFX SERIES® OPERATION MANUAL
SECTION 13:
Service and Maintenance
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS)
• All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 385 of 402
Error Source Code Category Error Message Possible Cause Resolution
Front panel
Error 190 Error Master unit nodes not
found. Error during discovery.
One or more nodes in
Master unit not found Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Front panel
Error 191 Error Fast scan failed. Error during discovery.
Fast scan discovery failed Check all parallel cables
between units. Run
parallel unit discovery
from System menu to
recover
Front panel
Error 192 Error Undetectable node exists. An inconsistency was
detected in the power
source's internal
communication network. Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Front panel
Error 193 Error An invalid firmware type
exists. Firmware Error. One or
more nodes report invalid
firmware type Check for correct
firmware image file and
version.
Primary Fault 200 Error LLC primary/auxiliary
current peak limit
exceeded.
Primary Fault 201 Error LLC/PFC gate driver fault
or hardware OVP.
Primary Fault 202 Error Controller missed
heartbeats from master
front panel.
Primary Fault 203 Error LLC primary current
average limit exceeded.
Primary Fault 204 Error LLC auxiliary current
average limit exceeded.
Primary Fault 205 Error PFC current peak limit
exceeded.
Primary Fault 206 Error PFC DC bus voltage limit
exceeded.
Primary Fault 207 Error Gate driver fault Gate driver fault occurred
in Input Buck Converter. Check for correct AC
input voltage connection.
Primary Fault 208 Error Input buck switching
time.
Primary Fault 209 Error AC input current
exceeded RMS limit for
too long.
Primary Fault 210 Error Unbalanced current in
PFC boost converters.
Primary Fault 211 Error PFC efficiency protection.
Primary Fault 212 Error AC input: voltage is below
minimum.
Primary Fault 213 Error AC input: missing phase.
Primary Fault 214 Error PFC DC bus voltage
regulation lost.
Primary Fault 215 Error PFC DC bus voltage limit
exceeded. CLA OVP Trip