AFX SERIES® OPERATION MANUAL
SECTION 8:
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS)
• All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Page 283 of 402
Command Syntax
SYSTem:COMMunicate:LAN:HOST:CONFigured
Description
Sets the network host address. The host address is the portion of the
address used to identify hosts (any device requiring a Network
Interface Card, such as a PC or networked printer) on the network.
The network ID, by contrast, is the portion of the address that refers
to the network itself.
Parameters
ddd.ddd.ddd.ddd (four octets ranging in value from 0 to 255
representing one 16 bit unsigned integer value each.
Parameter Format
<cr>
Example
SYST:COMM:LAN:HOST 132.18.21.0
Query Format
SYSTem:COMMunicate:LAN:HOST:CONFigured?
Returned Data Format
<cr>
Query Example
SYST:COMM:LAN:HOST:CONF?
132.18.21.0
Command Syntax
SYSTem:COMMunicate:LAN:PASSword
Description
Assign a password to enable or disable LAN communications. This
feature allows the owner/operator to disable or enable remote LAN
access or limit functionality over LAN.
Note: There is no query format for this command so the password
code cannot be queried back.
Parameters
Four digit passcode
Parameter Format
<nr1?
Example
SYST:COMM:LAN:PASS 1234
Command Syntax
SYSTem:COMMunicate:LAN:PORT
Description
Sets LAN interface port address. For SCPI message communications,
the standard port number is 5025.
Parameters
1024–49151, default = 5025
Parameter Format
<nr1>
Example
SYST:COMM:LAN:PORT 5025
Query Format
SYSTem:COMMunicate:LAN:PORT?
Returned Data Format
<nr1>
Query Example
SYST:COMM:LAN:PORT?
5025
Command Syntax
SYSTem:COMMunicate:LAN:PORT:TELNET
Description
Sets the port address for TELNET protocol
Parameters
1024–49151, default = 5024
Parameter Format
<nr1>
Example
SYST:COMM:LAN:PORT:TELNET 5024
Query Format
SYSTem:COMMunicate:LAN:PORT:TELNET?
Returned Data Format
<nr1>
Query Example
SYST:COMM:LAN:PORT:TELNET?
5024
