California Instruments 2001RP, User And Programming Manual

Page: 15 / 130

User and Programming Manual - Rev N
2.3 System Specification
Parameter Specification
Setup storage Eight non volatile front panel setup registers available through
interface. Power on setting register available from front panel.
Interface (Option package -OP1 required)
RS-232C Bi-directional serial interface
Rear panel connector: 9 pin D shell
Handshake: CTS, RTS
Data bits: 8
Stop bits: 1
Parity: None
Baud rate: 19200
Command syntax: IEEE 488.2 commands and SCPI
IEEE-488 GPIB Interface
Rear panel connector: 24 pin D-shell
IEEE address: set using DIP switch on rear panel from
0 to 31
IEEE functions:
SH1, AH1, T8, L4, RL2, SRQ 0
,
PP 0
,
DC 0
,
DT 0
,
C0
Terminators: LF, CRLF, EOI
Command syntax: IEEE 488.2 commands and SCPI
Remote Inhibit (Option package -OP1 required)
Rear panel connector: BNC
Input Contact closure to ground or logic low TTL
signal required to turn off output.
Automatic recovery when RI signal is
removed.
Function Strobe (Option package -OP1 required)
Rear panel connector: BNC
Output Active low TTL signal. Signal driven low for
approximately 400
µ
sec any time output
voltage or frequency programmed value
changes. Signal level may be changed by
removing jumpers to open collector.
6 April 2007 2001RP