California Instruments 2001RP, User And Programming Manual

Page: 112 / 130

User and Programming Manual - Rev N
10.9.1 *CLS
This command clears the following registers (see chapter 12 for descriptions of all status
registers):
•
Standard Event Status
•
Status Byte
•
Error Queue
Command Syntax *CLS
Parameters None
10.9.2 *ESE
This command programs the Standard Event Status Enable register bits. The programming
determines which events of the Standard Event Status Event register (see *ESR?) are
allowed to set the ESB (Event Summary Bit) of the Status Byte register. A "1" in the bit
position enables the corresponding event. All of the enabled events of the Standard Event
Status Enable Register are logically OR-ed to cause the Event Summary Bit (ESB) of the
Status Byte Register to be set. See Section 16 for descriptions of the Standard Event Status
registers.
The query reads the Standard Event Status Enable register.
Table 10-2: Bit Configuration of Standard Event Status Enable Register
Bit Position 7 6 5 4 3 2 1 0
Bit Name PON not
used
CME EXE DDE QYE not
used
not
used
Bit Weight 128 32 16 8 4
CME Command error DDE Device-dependent error
EXE Execution error QYE Query error
PON Power-on
Command Syntax *ESE <NRf>
Parameters 0 - 255
Power-On Value 128
Example *ESE 129
Query Syntax *ESE?
Returned Parameters <NR1>(Register value)
Related Commands *ESR? *STB?
2001RP April 2007 103