User and Programming Manual - Rev N
[SOURce:]VOLT:RANGe:AUTO
This command sets the AC source range to the AUTO mode. While in AUTO mode, the AC
source automatically switches to the optimal voltage range for the voltage programmed.
Note that switching voltage ranges causes the output to be interrupted momentarily. If
power to the unit under test cannot be interrupted, the AUTO range should not be used.
To determine the actual voltage range in which the unit is operating, the VOLT:RANG?
command query can be used.
For 2001RP-AV models configured for single voltage range, only one range is available. In
this case, the VOLT:RANGe:AUTO command has no meaning and should not be used.
The maximum current limit that can be programmed at a given time depends on the voltage
range setting in which the unit is presently operating. Programming a current limit value that
exceeds the high voltage range capability does NOT cause the voltage range to change,
even while in AUTO mode. Only voltage changes can prompt an automatic voltage range
change.
Command Syntax
[SOURce:]VOLTage:RANGe:AUTO <Bool>
Parameters
<Bool> 0 | 1
*RST Value
0
Examples VOLT:RANG:AUTO
1
Query Syntax
VOLT:RANG:AUTO?
Returned Parameters
<Bool>
Related Commands
VOLT LIM:VOLT? VOLT:RANG:LEV
2001RP April
2007
93
Summary of Contents for 2001RP
