Cagiva Navigator, Workshop Manual

Page: 320 / 407

E.22
SUSPENSIONS AND WHEELS
• Remove the oil seals. Using a drift of the correct diameter, knock
out the roller bearing from its seat, exerting pressure on the external
diameter of the bearing.
Carry out the substitution of the bearings and reassemble in the
reverse order of removal. Check the condition of the bushes and the
O-rings on the balancer. If wear is noted, substitute the bushes in
the same way as the roller bearings are substituted.
Pay particular attention to the assembly of the oil seals. They
must be inserted into their relative seats by using a drift on
the external diameter.
• Check the play of the spacers 7 inside the bearings.
• If excessive play is found, substitute the bearings on the balancer.
To remove the connection rod of the rear suspension, it is necessary
to remove the following components:
• Remove the chain roller 1.
• Unscrew the two chain guide fixing screws 2 indicated in the figu-
re.
• Push down the chain guide 3.
The spindle 4 relative to the fixing nut of the connection rod to the
frame is therefore left free.
• Remove the nut 5.
• Remove the connection rod 6 of the suspension.
• Remove the entire compensator assembly.
1
2
4
2
3
7
7
5
6