Cagiva Navigator, Workshop Manual

Page: 256 / 407

D.138
ENGINE
CHECKING THE GENERATOR STATOR AND THE CRANK-
SHAFT POSITION SENSOR
Refer to section G.
SERVICING THE GENERATOR STATOR AND THE CRANK-
SHAFT POSITION SENSOR
When replacing the generator stator or the crankshaft position sen-
sor, apply specific product to generator stator fastening bolts 1, clamp
bolt 2 and crankshaft position sensor fastening bolt 3, and then tighten
with the specified torque.
Specific product: LOC-TITE 243
Tightening torques:
Generator stator fastening bolt 1 10 N·m (1,0 kg-m) (7.3 lb·ft)
Generator stator clamp bolt 2
5.5 N·m (0,55 kg-m) (3.96 lb·ft)
Crankshaft position sensor fastening bolt 3
5.5 N·m (0,55 kg-m) (3.96 lb·ft)
CHECKING THE STARTER COUPLING
Fit the starting driven gear on the starter coupling and turn the driven
gear manually to ensure that the coupling moves freely. The gear
turns in one direction only. If strong resistance opposes rotation,
check the starter coupling and the contact area between the cou-
pling and the driven gear for wear or damage. If any damage is
found, replace the damaged parts with new ones.
CHECKING THE STARTING DRIVEN GEAR BEARING
Check the starting driven gear bearing for damage.
SERVICING THE STARTER COUPLING
• Remove the starter coupling fastening bolts.
• Remove one-way coupling 4, guide 5 and starter coupling hous-
ing 6 from generator rotor 7.
7
6
4
5
1
2
3