Cagiva Navigator, Workshop Manual, Page: 371 / 407

G.34
ELECTRICAL EQUIPMENT
+ -
INSTRUMENT PANEL BULB SUBSTITUTION
To gain access to the various warning light bulbs and the bulbs that
illuminate the instruments, operate as follows:
• Remove the windshield and the nose fairing by unscrewing the six
fixing screws.
• Extract the instrument panel from its anti-vibration housing and
disconnect the electrical wiring.
• Open the instrument panel assembly by removing the 7 screws 1
indicated in the figure.
• Pull out the correct bulb holder, remove the blown bulb and substi-
tute it.
All the bulbs are of the bayonet fixing type.
Reassemble the instrument panel assembly in the reverse order of
removal.
FRONT DIRECTION INDICATOR BULB SUBSTITUTION
To gain access to the direction indicator bulbs, it is necessary to
remove the fuel tanks as described in Chapter B.
Carry out the bulb changes as follows:
• Disconnect the indicator lead from the main wiring circuit in the
handlebar compartment.
• Remove the screws 2 that fix the indicator body inside the fuel
tank.
• Slide out the indicator body.
• Remove the two screws 3 that fix the lens to the indicator body.
• Remove the lens and substitute the blown bulb.
• Proceed with reassembly in the reverse order of removal.
REAR LIGHT AND REAR DIRECTION INDICATOR BULB SUB-
STITUTION
To gain access to the rear direction indicator bulbs, it is necessary
to lever the lens out of its position by inserting a small screwdriver
into the niche at the side of the lens 4.
After having removed the lens, remove the bulb from its holder and
substitute it.
1
1
1
2
3
4