Cagiva Navigator, Workshop Manual

Page: 135 / 407

D.17
ENGINE
• Turn in or out adjuster 8 under the sheath to obtain 10-15 mm
(0.3937-0.5905 in) of play A at the end of the clutch lever.
Clutch lever play: 10-15 mm (0.3937-0.5905 in)
• Fit the cable on the generator cover and momentarily place throw-
out lever 1 on the push rod.
• Pull the cable and adjust the angle of the throw-out lever end within
5-10 degrees by rotating adjuster 2.
• Tighten counternut 3.
• Fully screw in throw-out 4 onto the throw-out lever and place both
parts on the push rod.
Grease the seal lip and the throw-out balls.
Specific product: AGIP GREASE 30
Position the throw-out as shown in the figure at the right.
• Fully tighten the throw-out fastening bolts with the related spacer.
Apply a small quantity of threadlocking product to the throw-out fas-
tening bolts.
Specific product: LOC-TITE 243
• Install throw-out return spring 5.
• Slowly rotate adjusting screw 6 until resistance is felt.
• From this position loosen adjusting screw 6 by 1/4 of a turn and
tighten counternut 7.
1
2
3
5
6
7
4