SmartSwitch ATM Switch Reference Manual 2-9
Console Commands
AtmFilter
AtmFilter
Use AtmFilter to manage ATM filters on the switch.
Operators
add, delete, modify, show
Parameters
In the Output Parameter table below, (
</d>
) indicates parameters that are available only through the
show atmfilter
/d
(detailed) command.
Input Parameter
Description
Value/Field Size
Default
[AtmFilterName]
Name of the filter.
15-characters
maximum
FILTERXXX, where XXX
is the index.
[AtmFilterType]
Type of the filter.
Admit, Deny
[SrcAtmAddress]
Source (calling party) address (for
which this filter should be applied).
20-bytes maximum
[SrcAtmAddressMask]
Mask of the source ATM address.
20-bytes maximum
Default mask is created
from the SrcAtmAddress.
[DstAtmAddress]
Destination (called party) address
(for which this filter should be
applied).
20 bytes maximum
[DstAtmAddressMask]
Mask of the destination ATM
address.
20-bytes maximum
Default mask is created
from the DstAtmAddress.
Output Parameter
Description
[FilterName]
Name of the ATM filter.
[FilterType]
Type of the ATM filter. Possible values are: Admit or Deny.
[TotalAdmits]
Number of calls that were acted on by this filter that have passed through.
[TotalDenies]
Number of calls that were acted on by this filter that have not passed through.
[ReferenceCount]
Number of filter sets that are using this filter.
