1-6 SmartSwitch ATM Switch Reference Manual
Switch Attribute Entries
Introduction
Parameters
Most switch attributes have input or output parameters (or both). If an attribute has parameters, they are listed in tables
under a “Parameters” heading. You enter input parameters at the console command line. You view output parameters
at the console screen after the command executes. Some input parameters have default values (shown in parenthesis).
You do not need to type an entry if you accept the default.
Following is an example of the format of input and output parameter tables.
In the output parameter table below, </d> indicates parameters available only in detailed display mode. To view the
display for these parameters, type
/d
after the attribute in the command string (for example:
operator attribute /d
).
stop
Stops an object
update
Upgrades firmware
Input Parameter
Description
Value/Field Size
Default
[ATMAddress]
ATM address assigned to the port.
13-20 byte hex-based format
separated by colons.
No default
[ClientNumber]
Number of the client. Each client on
the switch must have a unique client
number. Client numbers are shared
between LAN emulation (LANE) and
IP/ATM (IP over ATM) clients.
0 to 127, or All
All
[InterfaceType]
Interface type advertised by the port.
Private, Public
Private
[SigRole]
Signaling role of the port. Other is used
only for autoConfig and pnni10.
Network, Other, User
Other
Output Parameter
Description
[Port ID]
Same as the [PortNumber] input parameter.
[Intf Type]
Same as the [InterfaceType] input parameter.
[Sig Role] </d>
Signaling role of the port.
[Client Address] </d>
ATM address of the client.
Table 1-1
List of Operators (Continued)
Operator
Action