SmartSwitch ATM Switch Reference Manual 2-283
Spvc
Spvc
Use Spvc to add, delete, or show soft PVCs (SPVCs) on the switch. An SPVC connects this switch (the source switch)
to a switch across the ATM network (the target switch).
Note
Before adding an SPVC at this switch, you must configure the target address at the
target switch.
Operators
add, delete, show
Parameters
Input Parameter
Description
Value/Field Size
Default
[PortNumber]
Port number on the switch. (Physical port used
as SPVC source port.)
A1 to B4 (2500 family),
1A1 to 8B4 (6500),
or All
All
[SourceVpi]
VPI allocated to the SPVC source port.
[SourceVci]
VCI allocated to the SPVC source port.
[DestinationSelectType]
Specifies whether or not the destination
VPI/VCI input at the source switch must be
used as the target port (at the target switch). If
you specify Required, the VPI/VCI specified in
the [DestinationVpi] and [DestinationVci] input
parameters must be used as the target port. If
you specify Any, the target switch can use any
VPI/VCI as the target port.
Required, Any
Required
[DestinationVpi]
VPI allocated to the target port.
[DestinationVci]
VCI allocated to the target port.
[TargetAddress]
Destination (target) address to which the SPVC
should attempt to connect.
20-byte address
[ForwardTrafficDescriptor
Index]
Index of the forward (source to target) traffic
descriptor.