BYD G3 AUTO Owner’s Manual
43
Front Reading Light
●
Functional positions of front reading
light switch is shown in the figure above.
Front Windshield Wiper and
Washer
This switch is used to control the
operation of front windshield wiper and
washer, with 5 functional positions:
MIST: Mist mode
OFF: turn off the wipers and washers
INT: intermittent operation
Low: continuous operation at low
speed
HI: continuous operation at high speed
To select a functional position, just
push the control handle
upwards/downwards.
At LO and HI mode, the wiper will wipe
continuously.
To set the wiper to MIST mode, push the
control handle upwards from OFF
position. The wiper will wipe at high
speed until you release the control
handle. In this way the windshield can
be cleaned quickly.
At INT mode, the wiper will wipe once
each 3-4 seconds, which is suitable for
lightly rainy days.
To spray cleanser, push the control
handle to yourself. The cleaner will
spray cleanser with the wiper wiping.
When releasing the switch, the cleaner
stops spraying cleanser and the wipers
stop after several cycles.
In freezing weather, before using
cleaner you shall warm up the
windshield with defroster, which can
prevent the cleanser from freezing on
windshield and affecting the front view.
Note
When the windshield is dry, do
not use wiper or the glass may be
scratched.
[Add Cleanser]
If the cleaner does not function, the
cleanser tank may be empty. Please
check the cleanser level. If the cleanser
level is below “LOW” mark, you shall
refill the cleanser.
