BYD G3 AUTO Owner’s Manual
144
If headlight or other electric devices
do not work, please check the fuses.
When necessary, replace the fuses.
For information on location of fuses, see
Section 7-1 “
Location of Fuses
”.
Turn off ignition switch and other
malfunctioning devices. Pull out the
fuses with potential malfunction
vertically and check them.
Find out which fuse has trouble. Circuit
name of each fuse is indicated on cover
of the fuse box. See Chapter 8 for
control function of each circuit.
Pull out A type fuse with a puller. The
puller is at location 19 in figure “Engine
Compartment” in Chapter 8.
If you are not sure whether the fuse is
burnt out, replace it with a good one.
If the fuse is burnt out, insert a new
fuse into the fuse socket.
Only install a fuse with amperage
specified on the fuse box.
If there is no spare fuse in emergency
situation, you can pull out “29. Indoor
Light” fuse, which is not essential in
driving, and substitute it for a fuse with
the same amperage.
If there is no fuse of the same amperage,
you should choose a fuse with lower
amperage; and do try to get a fuse with
the amperage as close to the rated
amperage as possible. If you use a fuse
with lower amperage, it may be burned
out again, but this doesn’t mean the car
has problem. You shall install a proper
fuse as soon as possible, and put back
the substitute fuse in place.
It is recommended to keep a set of
spare fuses on the car for emergency
use.
If a new replaced fuse is burnt out
immediately, the electrical system may
have problem. Contact BYD service
station for a check as soon as possible.
Tips
Never use a fuse with higher
amperage than the rating
amperage or use any other
objects to replace the fuse,
otherwise it may cause serious
damage and may lead to fire.
Add Cleanser
If the cleaner does not work, the
cleanser tank may have been empty.
Check the cleanser level on the
content gauge. If the level is below
“LOW” mark, you shall add cleanser.
