BYD G3 AUTO Owner’s Manual
39
Turn Signal Lights
To give out turn signal, push the light
handle forward/backward to position
1.
The ignition switch shall be on “ON”.
After the vehicle has finished turning,
the handle will reset to its original
position automatically; but in lane
changes, you must reset it manually.
To give out lane change signal, push the
handle upwards/downwards to position
2 and hold there.
If the green turn signal indicator on the
combination instrument flashes at a
higher speed than normal, it means front
or rear turn signal bulb is burnt out.
Headlight and Turn Signal Lights
(if auto light control system is
available)
Headlight
Turn on the following lights: rotate
light adjustment knob.
Position 1 – width-indicator lights,
number plate light and combination
instrument background light, etc.
The green indicator on the combination
instrument indicates that the
width-indicator lights are turned on.
Position 2 – headlight and all above
mentioned lights.
Position 3 (“Auto”) – headlight and/or all
light (same with position 2)
These lights will turn on/off according to
environment brightness automatically.
If you need to turn on lights when
entering dark places, such as tunnel,
garage, rotate the light adjustment knob
to position 2 to turn on headlight.
Illumination intensity sensor is located
on the top of driver’s instrument panel.
Do not leave any objects within this area
or stick any object on the windshield
around this area to avoid shutting light
from the sensor.
If you open driver’s door when ignition
switch is on “ACC", “LOCK” or removed
and when headlight switch is turned on,
the headlights will go out automatically.
To turn on the light again, turn the
ignition switch to “ON” and turn on the
headlight switch. If the car will be parked
for over one week, make sure headlight
switch is turned off.
