4
1. Setup
a.
Robot and Net Assembly
b.
Power Supply (Input: 100-240V, Output: 24V DC, 3A)
c.
Control Panel
d.
Control Panel Cable
e.
Control Panel Bracket
Other parts: Hex wrenches (2 and 4 mm) for wheels, Wheel Adjust-
ment Gauge (black tube with fins), spare rub-ber bands for the Side
Nets, Velcro strips. White, steel strips to repair of the deflector
plate.
1.
Place the robot on top of your table tennis table. Fold apart
both sides of the net at the same time until the first stop (Photo
1A). Rotate towards you the curved tubular Support Legs into
the position as seen in Photo 1b (about 15–20 cm, or 6-8 in.,
apart).
2.
Rotate the entire robot 180° with the Support Legs facing away
from you. From behind, grasp the robot with both hands on the
bottom of the Base. Pick up the robot, angle the Support Legs
downward, slip them under the end of your table tennis table,
and push the robot onto the end of the table. Gently let go of
the base and the robot will hang by its own weight as seen in
Photo 2.
Please note that AMICUS robots are designed to fit onto 25 mm
(1 in.) thick tops. If your top is less than 25 mm thick, you will
need to adjust the Support Legs using the height adjusting
screws. Turn the screws inward until the thickness difference
between 25 mm and your particular table surface is sufficiently
equalized.
CAUTION:
Please use the included longest Velcro strip to help
secure the robot to the end of the table. This is especially im-
portant if children play around the table. The Velcro strip helps
stabilize the robot to prevent it being knocked off the table.
3.
Loosen the large Black Knob found on the rear of the Ball Tube.
Rotate the head 180° and then pull the head upwards until the
3rd coloured ring on the tube is just visible (Photo 3A), then
tighten the Black Knob to hold it in place (but not too tightly).
Lastly, fasten the Head Cable coming from the head to the serial
connector found on top of the Base (Photo 3B).
Photo 1A
Photo 1B
Photo 2
