18
3.
While this Linking procedure is counting down, press at least 1 button of the 4 of the remote on.
Additional remotes (4 maximum) can be linked to the same Robot by pressing a different button on
the different remote switches during this step.
4.
When the countdown has finished, the Linking process ends and the display goes blank.
5.
Test your remote by pressing the A button to see if your robot begins throwing balls.
Changing The Battery In Your Remote
The Remote is powered by two 3V, CR2016 button cell batteries. After long use, the batteries will run
down and will need to be replaced. After purchasing replacement batteries, open your remote by
inserting a coin or flathead screwdriver in the slot located on the wide end of the Remote and twisting
to pop it open.
Remove the circuit board containing the battery. With your thumbnail, pull the battery holder away
from the circuit board. Pop the two depleted batteries out of the battery holder and replace with fresh
batteries. When inserting into the battery holder, be sure the positive side (+) of both batteries face up.
Re-insert the battery holder into the circuit board.
Reassemble the circuit board into the top housing (battery side up). Position the U-shaped metal piece
around the outside of the top housing. Then place the bottom housing on top and press the top and
bottom housings together, starting at the narrow end and working your way to the wide end until the
housings snap in place.
Take Down, Storage, & Transport
Upon finishing your training session, please
power off your robot by unplugging from power;
or alternatively, plug your robot into a power
strip and use the switch on the strip to turn the
power off.
If you’re ready to remove your robot from the
table temporarily, please follow these steps:
1.
Unplug the Power Supply from the outlet and
the base. Unplug the Control Panel Cable
from the base and the Control Panel. Roll these cables up and place them temporarily on your table.
2.
Disconnect the rubber bands that connect your Side Nets to your table. Place the Side Nets in the
Ball Collection Tray.
3.
Fold up the Net until the first stop of the folding mechanism. Unhook your robot from your table and
set it on your table with the open end facing you.
4.
Place your rolled-up cables, Control Panel, and Control Panel Bracket in the center area of the net
on top of the balls (you do not need to remove the balls).
