4
Read the confirmation and click
Yes
.
5
The LinkStation will be restored to its factory default settings.
Initializing Using the Function Button
You can also initialize the admin password and IP address with the function button. The IP address will only be
restored from manual to DHCP. It is enabled by default.
1
Turn off the LinkStation.
2
Turn the LinkStation on while holding down the function button until the power LED flashes amber.
3
Initialization will start. Do not power down the LinkStation while the power LED is blinking.
4
When the power LED glows a steady white, initialization is finished.
5
Once you reset the admin password, open Settings and run the setup wizard to configure a new password.
Note:
To disable the function button reset, navigate to
System Settings
>
Reset
and clear the “Enable initialization of
the admin password and DHCP settings” checkbox. Be careful with this option! If this is cleared and you lose your
admin password, you will not be able to reset it.
113
Chapter 8 System
Summary of Contents for LinkStation 500
