Bticino D45, Technical Manual

Page: 27 / 156

25
D
45
VIDEO
DOOR
ENTR
Y SY
STEM
322040 - auDio hanDset
Setup notes
1 . During the setup operations, if no keys are pressed for 10 s
the device will emit three short sound and return to standby .
2 . If during the setup operation the wrong key is pressed
or the wrong parameter is entered, 3 short sounds will
be heard . At the same time the device will return to the
initial installation setup status .
3 . During installation setup status the handset stops all call
functions and cannot respond to any calls . However, if any
call is received, a short sound will be heard as indication .
4 . When the power is reconnected the parameters set
during the setup process will still be valid .
5 . The functions of each pushbutton while in installation
setup status:
n
Long Press of (MC) Switchboard call key: select the
submenu;
n
press the (MC) Switchboard call key pushbutton: change
parameter;
n
door lock release pushbutton: select setting item or exit .
installation settings
Enter the initial installation setup status.
At standby, press and hold the door lock release pushbutton
until 1 long beep is heard . The call light will be off . Enter the
initial installation setup status without selecting any submenus .
Note: during the installation setup the handset cannot make calls. If any call is
received, a short sound will be heard as indication. However the handset will be
unable to answer.
Functions
322040 is an audio handset . It has basic functions such as
VDP and door lock release . It’s small in size and has a low
power consumption .
outlook anD connector
Introduction
Unless otherwise specified, the functions described below
are all in normal mode .
Meaning of the standby status
When there is no calls or no settings are being entered, this
manual will indicate the unit as in standby status .
installation notes
1 . Install Small EP.
When installing a Small EP, this must be connected to
master IU when there are 2 or 3 IUs in the apartment .
2 . Installing the electric door lock.
When connecting the Small EP to the electric door lock,
item 323015 is necessary for performing the door lock
release function;
3 . Install the SOS external switch
Audio handset
322040
2
1
3
4
6
7
8
5
legenD:
1 . Handset
2 . Door lock release key
3 . (MC) Switchboard call key
4 . Communication LED
5 . Serial interface connector
6 . System BUS connector
7 . Small EP connector
8 . External SOS alarm connector
Function setup
SOS alarm function
In case of external SOS alarm the switch or pushbutton
changes to alarm status, the handset will send SOS alarm
message to Switchboard .