Bticino D45, Technical Manual

Page: 11 / 156

9
D
45
VIDEO
DOOR
ENTR
Y SY
STEM
Mode 7 and Mode 8 : When there are several zones in one
project and we need the zone number for a call, we can
select one of them . Take Room 1 5/F Unit 2 Building 101 of
Zone 2 for example, which can be coded at 02-101-02-0501 .
Mode 7: 88-888-88-8888
Mode 8: 88-888-88-88A
BAckBoNE EP oR MAIN EP
F F u u b b r r
Mode 7: 88-888-88-8888
88
Zone number
888 building number
88
unit number
88 Floor number
88 room number
Mode 8: 88-888-88-88A
88 Zone number
888 building number
88
unit number
88 Floor number
A
room number
5 . Select 5 to complete the settings of the configuration
parameters of the entrance panel .
As per the prompt on the display interface, we can set the
address of the entrance panel, the floor number of the
said riser and the maximum number of handset installed
on each floor of the riser . We can also set the address of
the gate in relation to the Switchboard . When we come to
the setting interface, the configuration parameters of the
current entrance panel will appear . To make changes, enter
the desired number in serial order . After entering the 8 digit
number , just press # to confirm .
Note: This setting is only valid when the entrance panel does not use the parameter
of the configurator. For example, a certain place has been configured of its
resistance, and this setting shall be invalid.
6 . Select 6 to setup language: you can setup english or
other languages .
7 . Select 7 to setup pulse width for unlock . 1 to 99 seconds
can be set for lock opening pulse .
8 . Select 8 to set the password door lock release function .
As per the prompt on the display, we can enable or
disable the function to open the door lock by password .
When we disable this function, the menu item “7 to edit
the lock-open password” shall not be on display, and
therefore cannot be edited .
9 . Select 9 to complete the relevant settings of the
password door lock release function . There are three
available options:
• Set the door lock release password . Press the 1 key and
enter your desired group number and the password . On
entering the group number, if password of the group
already exist, it will be replaced by the new one . Press *
key to exit and return to the last operation .
• Delete the door lock release passwords one by one .
Press the 2 key and enter the group number you want to
delete . Press the # key to delete the password .
• Delete all the door lock release passwords . Press the 3
key and a prompt window will appear asking you if you
want to delete all the door lock release passwords or
not . Press the * key to exit and the # key to delete all the
passwords .