9- 44
Service Guide
LWE180, LWE200, LPE200, LPE240
© BT Europe AB
Electrical System – 5000 LWE 180/200 LPE 200
Parameters
T-code
Valid from serial number
Date
Order number
660, 661, 662, 497
723984-
2005-05-11
225553-040
Instructions for verifying parameter setting
•
Charge up the battery
•
Use the truck in its normal application until the battery indicator
shows an empty battery (0% on the display).
•
Disconnect the battery from the truck and allow the battery to rest for
at least two hours. NB! No charging or discharging during this peri-
od.
•
Measure the battery voltage at room temperature. If the voltage is
less than U
end
, see the table below, the parameter value must be re-
duced. If the value significantly exceeds U
end
, the risk of damage to
the battery is reduced. At the same time, the operating time of the
truck is reduced. If a longer operating time is required, the parameter
value can be increased. Maximum one unit.
•
Each change must be accompanied by a new verification of the pa-
rameter setting.
Parameter 22
You must specify the type of brake switch the truck is equipped with.
Mechanical switch = 0
Inductive sensor= 1
Parameter 25
Using this parameter you can specify a limit for when the next service is
to take place, from 0 to 2000 hours, in 50-hour steps. When it is time for
a service, warning 29 (C29) is shown in the display.
Parameter 28
Using this parameter you can select which button is to be used for lift/lower.
1 = Bottom lift/lower button activated (default)
2 = Top lift/lower button activated
3 = Both lift/lower buttons are activated
Battery type
Battery voltage at rest, U
end
Hawker Evolution
24,24 V
