BT Featurephone, Owner'S Handbook Manual

Page: 42 / 53

42
Miscellaneous features not covered elsewhere
(CONTINUED)
PSTN programming
There are various standard exchange lines (PSTN)
options available, but it is recommended that these
settings should only be altered from the original if there
has been a change of network connection and you are
aware of the consequences.
●
From the programming position, press the phone
set up key
P
and select ‘System programming’
●
Enter the PIN and select ‘Lines’
●
Select ‘PSTN programming’
●
Select the option as required
●
Press HANDS FREE to finish programming.
PSTN Default setting Alternate
programming
Tone dialling Tone dialling set Pulse
Time break Time break set Earth Recall
Loop calling Loop Calling not set Loop calling
(Not PSTN)
Guarded Clear Guarded clear set Unguarded
(No Trk-Trk)
CDS detection
See ‘Using Caller
Display and Calling
Line Identity Services
(CDS, CLI)’ for more
information
(CDS not set)
Fax detection See ‘Using a fax
machine with your
BT Inspiration’ for
more information
(Fax detection not set)
Reset options
Note.
This is the complete system-reset option, not the
individual extension reset feature.
There are two reset options available that should be
used with extreme care. Only use these options as
directed by BT.
Warning! The use of these options will at least cut
off all existing calls and with the ‘Reset to default !!’
lose all existing programming information.
●
From the programming position, press the phone
set up key
P
and select ‘System programming’
●
Enter the PIN and select ‘System’
●
Select ‘Reset Option’
●
Select ‘Reset!’Selecting this option will reset the
telephone system and cut all established calls off
●
If ‘Reset to default !!’ is selected, this option will reset
the telephone system, cut all established calls off and
remove all programming from the system and restore
the programme to the factory default settings.
Timers
Various timers can be adjusted to suit your
requirements.
●
From the programming position, press the phone
set up key
P
and select ‘System programming’
●
Enter the PIN and select ‘System’
●
Select ‘Timers’
●
Select the required timer to be changed
●
The current time is displayed on the top line
momentarily. The range for the timer is then
displayed, enter the duration
●
Confirm the new time
●
Press HANDSFREE to finish programming
Timers Range Default
setting
Recall on hold 001 - 180 30 seconds
Recall on transfer 001 - 180 30 seconds
Divert on no answer 01 - 30 11 seconds
Courtesy answer 01 - 30 30 seconds
Open the door 01 - 30 5 seconds
Door Intercom ring duration 01 - 30 30 seconds
Call park 001 - 250 180 seconds
Ringback time duration 01 - 30 30 seconds
Answer machine 01- 30 10 seconds