Service and maintenance of machine
Sherpa 1201 / 1401
103
1.
Lift the pick-up arm and secure it against
accidental lowering by means of support
trestles.
Carry out the following steps on both supporting
rollers:
2.
Unscrew the nut (1).
3.
Unscrew the counter nuts (2).
4.
Turn the nut (3) such that the supporting
roller
●
moves forward and the distance
between the milling drum/conveyor
drum and the ground increases or
●
moves backwards and the distance
between the milling drum/conveyor
drum and the ground is reduced.
5.
Retighten the counter nuts (2).
6.
Retighten the nut (1) at a tightening torque
of 400 Nm.
Fig. 135
8.22
Adjust scraper bar
The distance between the scraper bar and the ground should be
approx. 5 mm.
1. Lift the pick-up arm and open the milling
drum protection/the cutting unit.
2. Secure the machine against accidental
starting and rolling.
3. Secure the lifted pick-up arm against
accidental lowering by means of support
trestles.
4. Unscrew or remove all screws (1) at the
scraper bar (2).
5. Turn the scraper bar over if it is only worn
on one side, and/or move the scraper bar:
forward to reduce the distance to the
ground.
backwards to increase the distance to
the ground.
6. Retighten all screws (1) at the scraper bar.
Fig. 136
Summary of Contents for Strautmann Sherpa 1201
