Bruker minispec LF Series, User Manual

Page: 32 / 72

Operation
32 / 72 E164809_2_002
6.2.4.4 The minispec Menu
All commands concerning instrument settings are included in this menu item. The commands
for the magnet heater calibration and the receiver tuning are only available for BRUKER
service personnel and therefore are grayed with a normal software startup. The list of
commands depends on the status of the instrument (see figure). If there is no application
loaded, the list is enlarged by the commands
Connect and Disconnect .
Figure 6.6: The minispec Pull-Down Menu
The Connect/Disconnect Command
Once the system requirements for TCP/IP have been fulfilled, a software link between the
minispec software running on a PC, and the minispec must be initialized. To establish the PC
to minispec connection, select
minispec Connect . Alternatively you can select Connect in
the Welcome Box.
Enter the minispec serial number when prompted by the Connection Dialog Box.
The minispec serial number must have the form NFxxxx for mq-systems.
The minispec serial number, which is the host name of the minispec, is used to identify the
BRUKER minispec, controlled by the minispec software that is running on a PC in a TCP/IP
network.
Use the command Disconnect from the menu to disconnect from the current minispec (e.g.
prior to reconnecting to another minispec).