Assembly Step 1: Ensure Adequate Clearance:
Before placing the Firefly modules, it is important to
ensure adequate clearance will be available for both the
main footprint of the machine and maintenance access.
Since the Firefly Curing System is a modular system, the
main footprint of the machine depends on the exact
configuration you purchased. Consult your salesperson
for an engineering drawing of your particular system.
Clearance is required around the heat modules in order
to open control panel doors, pull out filters, and clean
camera boxes. See
Figure 7
for specific clearance
numbers.
45" CONTROL PANEL
DOOR OPEN CLEARANCE
45" FILTER ACCESS
CLEARANCE
3' CAMERA ACCESS CLEARANCE
(TOP OF MACHINE)
Figure 7: GENERAL CLEARANCES
Clearance is also required for the heat modules to slide
on their tracks for maintenance access to the center of
the machine. Ensure that nothing blocks the movement
of the heat sections front/back as shown in
Figure 8
.
HEAT SECTIONS
SEPARATE
Figure 8: ACCESSING CENTER OF SYSTEM
Assembly Step 2: Identify and Arrange:
Using the figures in this manual, identify the modules
that shipped with your dryer. Arrange the modules in the
location you wish to install the machine in the correct
orientations for your system. Below is a standard
configuration for a 2 heat section system. As the Firefly
system is a modular system, your configuration may be
different. Consult with Brown Manufacturing for the
exact layout of your system.
Use the leveling legs on each module to bring all the
sections to the same height and level. Shift the modules
as necessary to create a single, straight frame.
DRIVE
ROLLER
MODULE
CONTROL
KIOSK
PRIMARY HEAT
MODULE
DRONE HEAT
MODULE
TAKEUP
ROLLER
MODULE
EXHAUST
MODULE
COOLER
MODULE
TV STAND
(OPTIONAL)
Figure 9: STANDARD MODULE ARRANGEMENT
