Assembly Step 3: Connect Modules:
Remove the cover grills from the frames of each section.
Bolt each module to each adjoining module using the
connection holes at the end of each frame.
FRAME
ACCESS
COVER
FRAME
CONNECTOR
HOLES
Figure 10: FRAME CONNECTIONS
Assembly Step 4: Mount Accessories:
Depending on the exact configuration of your system,
you may have to locate and set into position some or all
of the following accessories:
-
Load Detect Sensors ()
-
Scanners (Mount on scanner stands)
-
Height Sensors ()
-
TV (mounts on TV stand –
Figure 9
)
Assembly Step 5: Install Belts:
First, loosen the Belt Tracking Knobs (
Figure 11
) on
both the front and rear of the machine. Slide the rollers
as far back as they will go.
BELT TRACKING KNOBS
BELT ROLLERS
Figure 11: LOOSENING BELT TENSION
Next, run the belt through the body of the machine. The
belt may have a flap covering the seam. Make sure when
the seam is on the top side of the roller, the attached side
of the flap is on top and moving in the direction of the
belt (
Figure 12
)
BELT MOVEMENT
DIRECTION
SEAM FLAP
(IF PRESENT)
Figure 12: SEAM FLAP ORIENTATION
Each end of the belt has a row of eyelets. Line up eyelets
together, and push the connector pin through (
Figure
13
).
CONNECTOR PIN
EYELETS
Figure 13: SEAM CONNECTION
